LA295 | Pentair Booster Pump Seal Bracket

$99.99
In stock
SKU
LA295
- +
Ask a Question

Ask a Question

LA295 | Pentair Booster Pump Seal Bracket

SKU#: LA295

Pentair Seal Bracket With Shaft Seal  For Pressure Side  Booster Pump LA01N LA295

$99.99

To remove seal
1. Stand motor on end, using one screwdriver slowly  pry seal out of impellar. Remove seal bracket and dislodge seal from backside of seal bracket using hammer and screwdriver.

Ask a Question
LA295 | Pentair Booster Pump Seal Bracket LA295 | Pentair Booster Pump Seal Bracket LA295 | Pentair Booster Pump Seal Bracket
LA295 | Pentair Booster Pump Seal Bracket
  • Product Details

    About this product

    Description

    To disassemble the booster pump 
    1. Turn off booster pump motor and close valves.
    2. Unscrew suction line in middle of volute.
    3. Loosen nuts and remove bolts between booster pump volute and seal bracket.
    4. On back end of motor remove cap. Use a crescent wrench or open end wrench to hold shaft from spinning.
    5. Hold wrench and turn impellar counter clockwise to remove.

    Highlights

    To re-assemble the unit
    1. After replacing the necessary parts, re-assemble by reversing order of steps 1-5 above.
    2. Ceramic seat must be perfectly clean of any foreign objects or dirt. If seat is not clean, it will cause leakage. The ceramic seat must go in with the side containing grooves facing into the center of the rubber gasket, otherwise it will leak.
    3. Replace impellar and seals if warped or discolored. This condition is caused by overheating due to pump running dry. Smooth surface of ceramic seal should be parallel to and facing away from back side of impellar.
    4. Silicone backside of metal flange on spring seal, push down until flush in center of seal bracket. Be careful not to get silicone on to spring seals contact surface.

    Features

    To remove seal
    1. Stand motor on end, using one screwdriver slowly  pry seal out of impellar. Remove seal bracket and dislodge seal from backside of seal bracket using hammer and screwdriver.

    Brand Information

    Founded in 1966, Pentair has engineered water solutions to filter, clean and sanitize water to its purest state, while automation equipment makes it all easy to control from anywhere so that you can truly enjoy your pool and spa.

    Visit Manufacturers Website
  • Q/A
    No Questions
WARNING! The following product(s) can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov