Hayward | SP1070BOND | Water Bonding Kit, Skim Master Skimmers

Installation Instructions:

1. Turn skimmer over for drilling access to bottom. Use a 3/8" drill bit.

2. Drill through the bottom of the skimmer at the recessed pilot point.

3. Drill straight avoiding the seal surface highlightes below.

4. Place bonding lug over hole and start mountiong screw.

5. Do not tighten mounting scre yet to allow for lug alignment.

6. With o-rings on post, screw fine thread end into lug until snug.

7. Rotate post counter-clockwise until hex flats are aligned as shown below.

8. Tighten mounting screw.

9. Place bonding plate on post, aligning hex details.

10. Secure plate with supplied nut. Torque to 75in lbs.

11. Attach system bonding wire (8 ga. Dolis conductor). Torque bolt to 75 in lbs.

NOTE: Before pouring concrete or backfilling dirt, have building inspector verify bonding.