GW7515 | Pentair GW7700 PoolShark Pool Cleaner Steering Kit

1. With a screwdriver, carefully work the rubber vacuum pad down over the lip of the Outer Housing, (see Figure 25).

2. Lift the Outer Housing straight up off of the chassis. Squeeze the tabs on the Bumper/Height Limiter Clips (inside the housing) to remove the Bumper/ Height Limiter. The Bumper/Height Limiter, Bumper/Height Limiter Boots, and Bumper/Height Limiter Clips pull apart, (see Figure 26).

3. Squeeze and pull the Sprocket Clips to release the Drive Shaft Assembly and Center Sprocket, (see Figure 27).

4. Pull the Oscillator Straight out from the bottom of the Outer Housing. Be careful not to lose the Sliding Seals, (see Figure 28).

5. Squeeze the latching tabs and pull up on the Swivel Housing and Swivel. The assembly will come up, releasing the Swivel Sprocket. Squeeze the latching tabs to remove the Clutch Clip, (see Figure 29).

6. Remove the Shaft Plug with the stainless steel shaft and the Large Steering Drive Assembly, (see Figure 30).

7. Remove the Oscillator Sleeve, releasing the Oscillator Sleeve Bushing and the Clutch assembly, (see Figure 31)