79112000 | Pentair Amerlite Bolt Replacement

For lights with stainless steel face ring:
(1) With the light resting on its base, align the face ring, and lens/gasket on top of the light shell as described in
Step 6. A NEW LENS GASKET MUST BE USED EACH TIME THE LIGHT IS REASSEMBLED.
The locking levers should all be hanging freely down to install over the lens and gasket. Before installing the
Unitension Clamp be sure that the gap at the ends of the clamp
is approximately 1 in. apart. Pull the ends of the Unitension
Clamp past one another to accomplish this.
(2) With the bent ends of the circular unitension clamp pointing
down spread the clamp and place it in the “U” recesses of
the locking levers. Be sure the bent ends of the clamp are
located between the pair of locking levers as shown in Figure
3, location A. Check to see that the clamp is properly
engaged with all of the levers.
(3) Turn the light so that it is now resting on its lens. Tighten the
bolt and nut until the distance between the ends of the clamp equals 1/4 inch or less; see Figure 4.