Pentair | GW7506 | GW7900 SandShark Pool Cleaner Seal Flap Replacement Kit
Pentair | GW7506 | GW7900 SandShark Pool Cleaner Seal Flap Replacement Kit
SKU#: GW7506
GW7506 Pentair Seal Flap Replacement Kit for GW7900 , SandShark Automatic Pool Cleaner
$16.99
-
Product Details
About this product
Description
1. With a screwdriver, carefully work the rubber vacuum pad down over the lip of the Outer Housing, (see Figure 33).2. Lift the Outer Housing straight up off of the chassis, (see Figure 34).3. Squeeze and pull the Sprocket Clips to release the Drive Shaft Assembly and Center Sprocket, (see Figure 35).4. Pull the Oscillator Straight out from the bottom of the Outer Housing. Be careful not to lose the Sliding Seals, (see Figure 36).5. Squeeze the latching tabs and pull up on the Swivel Housing and Swivel. The assembly will come up, releasing the Swivel Sprocket. Squeeze the latching tabs to remove the Clutch Clip, (see Figure 37).6. Remove the Shaft Plug with the stainless steel shaft and the Large Steering Drive Assembly, (see Figure 38).7. Remove the Oscillator Sleeve, releasing the Oscillator Sleeve Bushing and the Clutch assembly, (see Figure 39).8.If you need to replace the bumper, turn the housing/bumper assembly upside down and remove the two flex snaps holding the bumper to the housing, (see Figures 40 & 41). Use a piece of ½ in. (inside diameter) PVC pipe to slide over the flex snap ends to squeeze the flex snaps together so they can be slid out of the housing. Use a pair of pliers to pop the flex snaps off of the bumper.Highlights
Features
Brand Information
Founded in 1966, Pentair has engineered water solutions to filter, clean and sanitize water to its purest state, while automation equipment makes it all easy to control from anywhere so that you can truly enjoy your pool and spa.
Visit Manufacturers Website -
Specifications
ProblemCorrective ActionIf SandSharkdoesn't move or pulsates slowly or doesn't climb pool walls properly:Make sure that the main drain and all other suction lines are closed except the suction line to which the SandShark is attached.Check for sufficient flow through cleaner hose.Check for debris in the filter or the pump strainer basket.Check for debris in the SandShark's oscillator. Debris may prevent oscillator movement or restrict the flow through the cleaner.Check the oscillator for: damage; lost seals (there should be 4 seals): obstructed seals (seals should slide freely on the oscillator).Be sure that the short, soft flexible leader hose section is the first section in the hose assembly (next to the cleaner)
-
Q/A
No Questions
Log in
Create a Free Account
Please fill out sign-up form
Sign up with your social media account
Or
Fill out sign up form
Why create an account
Sign up with your social media account