(818) 818-6559
Free Shipping over $25
 
Toggle Nav
My Cart
Search
  • My Account
  • My Wish List
  • Sign In
  • Create an Account

GW7502 | Pentair GW7700 PoolShark Pool Cleaner Oscillator Kit

$16.99
In stock
SKU
GW7502
- +
Ask a Question

Ask a Question

GW7502 | Pentair GW7700 PoolShark Pool Cleaner Oscillator Kit

SKU#: GW7502

Pentair Oscillator Kit for GW7700 PoolShark  Automatic Pool Cleaner GW7502

$16.99

Ask a Question
See Details
GW7502 | Pentair GW7700 PoolShark Pool Cleaner Oscillator Kit GW7502 | Pentair GW7700 PoolShark Pool Cleaner Oscillator Kit GW7502 | Pentair GW7700 PoolShark Pool Cleaner Oscillator Kit
GW7502 | Pentair GW7700 PoolShark Pool Cleaner Oscillator Kit
  • Product Details

    About this product

    Description

    Disassembly
    1. With a screwdriver, carefully work the rubber vacuum pad down over the lip of the Outer Housing, (see Figure 25).
    2. Lift the Outer Housing straight up off of the chassis. Squeeze the tabs on the Bumper/Height Limiter Clips (inside the housing) to remove the Bumper/ Height Limiter. The Bumper/Height Limiter, Bumper/Height Limiter Boots, and Bumper/Height Limiter Clips pull apart, (see Figure 26).
    3. Squeeze and pull the Sprocket Clips to release the Drive Shaft Assembly and Center Sprocket, (see Figure 27).
    4. Pull the Oscillator Straight out from the bottom of the Outer Housing. Be careful not to lose the Sliding Seals, (see Figure 28).
    5. Squeeze the latching tabs and pull up on the Swivel Housing and Swivel. The assembly will come up, releasing the Swivel Sprocket. Squeeze the latching tabs to remove the Clutch Clip, (see Figure 29).
    6. Remove the Shaft Plug with the stainless steel shaft and the Large Steering Drive Assembly, (see Figure 30).
    7. Remove the Oscillator Sleeve, releasing the Oscillator Sleeve Bushing and the Clutch assembly, (see Figure 31)

    Highlights

    Features

    Brand Information

    Founded in 1966, Pentair has engineered water solutions to filter, clean and sanitize water to its purest state, while automation equipment makes it all easy to control from anywhere so that you can truly enjoy your pool and spa.

    Visit Manufacturers Website
  • Specifications
    Problem
    Corrective Action
    If PoolShark
    doesn't move or pulsates slowly or doesn't climb pool walls properly:
     
    Make sure that the main drain and all other suction lines are closed except the suction line to which the PoolShark is attached.
    Check for sufficient flow through cleaner hose.
    Check for debris in the filter or the pump strainer basket.
    Check for debris in the PoolShark oscillator. Debris may prevent oscillator movement or restrict the flow through the cleaner.
    Check the oscillator for: damage; lost seals (there should be 4 seals): obstructed seals (seals should slide freely on the oscillator).
    Be sure that the short, soft flexible leader hose section is the first section in the hose assembly (next to the cleaner)
  • Q/A
    No Questions
WARNING! The following product(s) can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov