78880200 | Pentair AquaLumin Silicone Lens Seal

$32.99
In stock
SKU
78880200
- +
Ask a Question

Ask a Question

78880200 | Pentair AquaLumin Silicone Lens Seal

SKU#: 78880200

Pentair Silicone Lens Seal for AquaLumin and AquaLumin III Energy-Efficient Nicheless Pool and Spa Lights 78880200

$32.99

Always install a new lens seal (P/N 78880200) whenever disassembling the light. Failure to do so may permit water to leak into the assembly which could cause (a) an electrical hazard resulting in death or serious injury to pool users, installers, or others due to electrical shock, or (b) breakage of the lamp or lens, which likewise could result in serious injury to pool users, installers, or others, or in damage to property.

Replacement Instructions

Ask a Question
78880200 | Pentair AquaLumin  Silicone Lens Seal 78880200 | Pentair AquaLumin  Silicone Lens Seal 78880200 | Pentair AquaLumin  Silicone Lens Seal
78880200 | Pentair AquaLumin  Silicone Lens Seal
  • Product Details

    About this product

    Description

    SECTION I. Replacing a lamp only.
    1. Turn off main electrical switch or circuit breaker, as well as the switch which operates the Nicheless Light itself.
    2. Unscrew the captive screw on the top of the light, then tilt the top of the light out from the wall and lift the bottom of the light out of the bracket. Unwind the excess cable that is stored in the back of the light.
    3. Place the light face down on the deck. Be careful not to scratch the lens.
    4. Remove the housing spacer from the back of the light.
    5. With a Phillips head screwdriver, remove the 10 screws on the back of the light.
    6. Turn the light over while holding the glass lens, remove the glass lens, plastic ring and lens seal.
    7. To remove the lamp, first grasp it on the left side, (when looking at the front of the light in a horizontal position). Then push
    the lamp to the right, (compressing the spring in the lamp socket), until the left side of the lamp comes free from the fixed
    socket end.

    Replacement Instructions

    Highlights

    Features

    Always install a new lens seal (P/N 78880200) whenever disassembling the light. Failure to do so may permit water to leak into the assembly which could cause (a) an electrical hazard resulting in death or serious injury to pool users, installers, or others due to electrical shock, or (b) breakage of the lamp or lens, which likewise could result in serious injury to pool users, installers, or others, or in damage to property.

    Replacement Instructions

    Brand Information

    Hayward Industries, Inc. is the largest manufacturer of residential swimming pool equipment in the world. Headquartered in Elizabeth, New Jersey, Hayward designs and markets the Totally Hayward® System, a complete line of state-of-the-art, energy efficient residential pool equipment including pumps, filters, heaters, heat pumps, cleaners, electronic control systems, electronic chlorinators, lighting, safety equipment.

    Visit Manufacturers Website
  • Q/A
    No Questions
WARNING! The following product(s) can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov